, Hyderabad. The commercially available formulations of famotidine were purchased from the local market. The HPLC grade water was prepared by double glass distillation and filtration through 0.45 mm filters. Acetonitrile of HPLC grade was obtained from E. Merck. (India) Ltd., Mumbai. Potassium dihydrogen phosphate, hydrochloric acid, hydrogen peroxide and sodium hydroxide of analytical grade are purchased from Qualigens Fine Chemicals Ltd., Mumbai. About 7.0 g of potassium dihydrogen phosphate was weighed accurately, transferred into a 1000 mL beaker and

dissolved in 500 mL of HPLC grade water, diluted to total volume and the pH of the resulting solution was adjusted to 7.0 by adding dilute sodium hydroxide solution. The mobile phase was prepared GDC-0941 nmr by adding of 600 mL acetonitrile to 400 mL of 0.7%potassium dihydrogen phosphate buffer of pH 7.0; the solutions were mixed well, degassed for 30 min. and filtered through 0.45 μm membrane filter. Stock solution (100 μg/mL) of the famotidine was prepared by dissolving accurately weighed 10 mg of famotidine standard or an amount powder equivalent to 10 mg

of famotidine standard in 70 mL of mobile phase in a 100 mL volumetric flask, sonicated and made up to the mark. Further working standard (10 μg/mL) was prepared by transferring 1.0 mL of the stock solution into 10 mL volumetric flask and diluted up to the mark with mobile phase, sonicated and filter through 0.45 μm filter. A series dilute solutions ranging from 5.0 to 20.0 μg/mL Tolmetin were prepared by taking different aliquots (0.5–2.0 mL) of the stock solution and diluted Sirolimus mw in similar manner. The chromatographic separation was carried out under the isocratic conditions. The

mobile phase was allowed to flow through the column at a flow rate of 0.2 mL/min for 10 min to equilibrate the column at ambient temperature. Chromatographic separation was achieved by injecting a volume of 6 μl of standard into Symmetry C18 (2.1 × 50 mm, 1.7 μm, Make: BEH) column, the mobile phase of composition potassium dihydrogen phosphate buffer of pH = 7.0 and acetonitrile in the ratio 40:60 v/v was allowed to flow through the column at a flow rate of 0.2 per minute for a period of 6.0 min. Detection of the component was carried out at a wavelength of 297 nm. The retention time of the component was found to be 0.595 s and the system suitable parameters like number of theoretical plates and tailing factor were found to be 8896 and 1.48 respectively. To evaluate system suitability parameters, a volume of 6 μl of famotidine working standard solution was injected into the analytical column, mobile phase was allowed to flow at a rate 0.2 mL/min for 3.0 min and the chromatograms were recorded at 297 nm using PDA detector. Typical chromatograms for standard and test were shown in (Fig. 2 and Fig. 3) respectively. System suitability parameters such as retention time, tailing factor and USP theoretical plate count of the developed method were found to be 0.595 min, 1.