5-7 Remelting the casted metal is usually
done whenever there is a casting failure or as a routine procedure where dental laboratories want to decrease the unit cost of a fixed partial denture. purchase Tolbutamide Hong et al. studied the effect of various percentages of reused silver-palladium alloy on the bond strength of porcelain and concluded that, 50% new alloy should be added to each casting button.8 de Melo et al. evaluated the shear bond strength between a porcelain system and 4 alternative alloys (2 Ni-Cr alloys and 2 Co-Cr alloys) and reported bond strength values ranging between 54 MPa and 71.7 MPa.9 However, none of these studies compared the effects of recasting on the bond strength of porcelain to both the Ni-Cr and Co-Cr alloys. Furthermore, it is unclear
from the literature, as to which bond strength test closely predicts the bond strength of metal-ceramic interface. Therefore, this study was designed to compare the bond strength of Ni-Cr and Co-Cr alloys with dental ceramic on repeated castings using shear bond test with a custom made apparatus. Materials and Methods The Ni-Cr alloy used in this prospective study was Wiron 99 (BEGO Ltd., Germany) composed of Ni 65, Cr 22.5, Mo 9.5, Nb 1, Si 1, Fe 0.5, Ce 0.5 and C max. 0.02. The Co-Cr alloy used was Wirobond C (BEGO Ltd., Germany) composed of Co 61, Cr 26, W 5, Nb 1, Si 1, Fe 0.5, Ce 0.5 and C maximum 0.02 (in % by Wt.). These alloy brands were selected for the study due to their biocompatibility, long-term
clinical usage and reliable processing methods. Ethical clearance from the institutional review board was obtained for the study. A rod with a length and diameter of 5 mm was machined to the sample dimensions used by de Melo et al. to prepare a metal die9 (Figure 1). The machined die was embedded in a putty silicone impression material (polyvinyl siloxane, aquasil soft putty, dentsply) to prepare a silicone index. Casting wax (thowax, yeti dental) was used to prepare the wax duplicates. All the wax duplicates were then sprued and invested in a phosphate bonded investment material (Bellasun, Bego) (Figure 2). Lost wax technique was followed, and samples were cast using centrifugal casting machine (OKAY PLUS, Galoni, Italy). After casting, samples were devested and sandblasted (Renfert, Basic master, TBS Pvt. Ltd). Metal samples that are free of voids and meeting GSK-3 the specimen dimensions were only considered for porcelain application. Following the manufacturer’s recommendations, opaque porcelain was applied to a clean metal surface using a brush. Dentine porcelain (VMK 95 Metal Ceramic; VITA Zahnfabrik, Bad Säckingen, Germany) was condensed into the putty index, which was used to standardize the porcelain thickness (Figure 3). The samples were removed from the index and fired in a porcelain furnace (Vacumat 40, VITA Zahnfabrik, Germany) (Figure 4).